Products

Epoxy Max 012

Two-component epoxy coating with low thickness and zero shrinkage (100% dry) applicable by roller. The product is endowed with good mechanical resistance, gives a glossy finish as well as the possibility of creating non-slip surfaces by using a sprinkling of quartz micro-granules or propylene dispersed granules mixed mechanically during the catalyzing phase.

WHAT IT’S FOR
It is a product suitable for the coating and protection of cement, concrete and similar screeds, EPOXY MAX 012 is ideal for the treatment of environments such as garages, ramps, warehouses, etc. (After application of EPOXY PRIMER H2O).

Description

Two-component epoxy coating with low thickness and zero shrinkage (100% dry) applicable by roller. The product is endowed with good mechanical resistance, gives a glossy finish as well as the possibility of creating non-slip surfaces by using a sprinkling of quartz micro-granules or propylene dispersed granules mixed mechanically during the catalyzing phase.

WHAT IT’S FOR
It is a product suitable for the coating and protection of cement, concrete and similar screeds, EPOXY MAX 012 is ideal for the treatment of environments such as garages, ramps, warehouses, etc. (After application of EPOXY PRIMER H2O).

METHOD OF USE

  • SURFACE PREPARATION
    Check that the surface to be treated does not have rising damp above 4-5%. Surfaces should be in good condition, dry, free of grease oil and polluting substances.
    Prepare the substrate by mechanical treatment (shot-peening or abrasive) and then remove the resulting powders. Any restoration of damaged parts must be carried out with specific mortars.
  • PRODUCT PREPARATION
    The mixing ratio of the two components that make up the product is as follows: component A 75% – component B 25%. Pour component B into component A, making sure to clean the walls and bottom of the jar with a spatula then mix thoroughly for a few minutes with a low-speed drill fitted with a spiral drill, until the product is perfectly homogenized.
  • APPLICATION
    EPOXY MAX 012 can be applied by short-hair roller or with a steel spatula.
    The product must be distributed evenly crossing the rollings and can be diluted with 5% ethyl alcohol. For the possible application of a second coat wait 12-18 hours, operating as above.

Reviews

There are no reviews yet.

Be the first to review “Epoxy Max 012”